I received my QuickStart board and am attempting to make it blink an led but am having no success. The power on light is on. Using the Propellor tool when I load an example using the F10 button (I am using ConstantBlinkRate) the red and Blue Rx TX leds flash. The led which looks like it should be on Pin 4 does not flash however. When I push F7 the program finds the Propellor chip on Com 18. So.....it seems to me that that the Propellor tool is finding the board and uploading to it but the board is not responding for some reason.
I tried the Simple IDE with similar results using the BlinkLight.side program. It compiled and loaded but no results blinking an led.
I have done searches looking for a cause of the led not blinking but I am not finding anything that helps. I am sure that I am missing something very basic and easy but for me it is not easy as I do not know what it is. I am still waiting for my Propellor books to learn but am eager to get this board to respond.
Any ideas for a real amateur with the Propellor board?
Thanks
Will
I tried the Simple IDE with similar results using the BlinkLight.side program. It compiled and loaded but no results blinking an led.
I have done searches looking for a cause of the led not blinking but I am not finding anything that helps. I am sure that I am missing something very basic and easy but for me it is not easy as I do not know what it is. I am still waiting for my Propellor books to learn but am eager to get this board to respond.
Any ideas for a real amateur with the Propellor board?
Thanks
Will